Velleman CHLSC2 - Manual (Page 4)

08.12.2010
covered by
• Only use th
device in a
• Damage ca
manual is n
not accept
problems
4. Use
Refer to the i
• Connect a
(connecting
matching w
• Obtain a su
PS1255) a
other end i
• Aim the rem
controller t
• Switch the
control. To
• Select the
correspond
• To increase
button
• Press the e
Strobe, Fad
5. Batte
Refer to illust
• The remote
battery (inc
• To (re)plac
cover [C1]
• Insert the
battery com
the remote
CHL
4
y the warranty.
he device for its inte
n unauthorised way
aused by disregard o
not covered by the w
responsibility for an
llustrations on page
LED strip (not includ
g tools not included
wire colours. Do not
uitable 12VDC/5A po
and connect it to the
into the mains.
mote control [B] to
to control the outpu
LED strip on with th
switch it off again,
desired light output
ding colour button o
e or decrease outpu
n (8 gradations).
effect buttons to gen
de or Smooth.
ery
tration C on page 2
e control uses 1 bat
cluded).
ce the battery, press
] and pull [C2] to s
battery with the righ
mpartment by pushi
e control until it snap
LSC2
ended purpose. Usin
y will void the warra
of certain guidelines
warranty and the de
ny ensuing defects o
e 2 of this manual.
ded) to the controlle
). Make sure to con
t short-circuit any w
ower adaptor (not in
e controller [A1]. P
wards the IR LED [A
t of the LED strip.
he ON button on the
press the OFF butto
t colour by pressing
n the remote contro
t brightness, press
nerate different effe
of this manual.
tery type 3V lithium
s on the side of the
lide it open.
ht polarity and close
ing it back into the
ps into place.
Rev. 01
©Velleman nv
ng the
nty.
s in this
ealer will
or
er [A2]
nect
wires.
ncl., e.g.
lug the
A3] of the
e remote
on.
the
ol.
the or
cts: Flash,
m CR2025
battery
e the
housing of