Velleman LX302 - Manual (Page 3)

LX302
V. 02 – 16/04/2013 3 ©Velleman nv
Familiarise yourself with the functions of the device before actually
using it. Do not allow operation by unqualified people. Any damage that
may occur will most probably be due to unprofessional use of the
device.
Use the original packaging if the device is to be transported.
All modifications of the device are forbidden for safety reasons.
Only use the device for its intended purpose.
4. Features
flash rate & intensity fader control
easy to use
chase effects for multiple units
no external power required.
5. Remote Controller
The controller allows you to control the functions more easily. Connect the
LX302 to the fixtures using a 3-pin XLR cable. The controller is able to
control up to 20 fixtures. Remove the terminator from the last LX301 in the
chain when using the LX302 controller. Install a signal splitter after the first
fixture if necessary.
1 blinder effect button
2 intensity fader
3 run/stop toggle switch
4 chase/sync toggle switch
5 flash rate fader
6 single flash button
6. Cleaning and Maintenance
All screws should be tightened and free of corrosion.
The housing, visible parts, mounting supports and the installation
location (e.g. ceiling, suspension, trussing) should not be deformed,
modified or tampered with; e.g. do not drill extra holes in mounting
supports, do not change the location of the connections…
Disconnect the device from the mains prior to maintenance activities.
Wipe the device regularly with a moist, lint-free cloth. Do not use
alcohol or solvents.
There are no user-serviceable parts.
Contact your dealer for spare parts if necessary.