Information sheet – Velleman MONSCA4N User Manual
Page 3
Information sheet
Velleman
®
3/3
Last update: 25/05/2010
4. Procedure
Inspection conditions
• Viewing distance is approximately 35 ~ 40 cm (for
inspecting adjacent dots and distance between defect
dots, this distance is much closer)
• Viewing angle is normal to the LCD panel (max. 10°
deviation)
• Ambient temperature is 25 ± 5°C
• Ambient humidity is 60 ± 5% RH
• Ambient illuminance is between 300 ~ 500 Lux.
• Input signal timing should be typical value.
A eye
position
B LCD panel
Inspection criteria
Refer to the definitions in §2.
N = number of defects.
defect type
limit
visual
defect
scratch
0.03mm ≤ W ≤ 0.1mm
L ≤ 10mm
N ≤ 4
defect
round 0.3mm
≤ Ø ≤ 1.0mm
N ≤ 5
linear
W ≤ 1.0mm
L ≤ 3.0mm
N ≤ 5
polarizer 0.3mm
≤ Ø ≤ 1.0mm
N ≤ 5
total allowed
N ≤ 10
electrical
defect
single dot
bright* N
≤ 6
dark N
≤ 6
total allowed
N ≤ 9
adjacent dots
2**
≤ 3 pairs
3**
≤ 2 sets
4**
≤ 1 sets
distance between 2 bright dots
≥ 10mm
line defects
N = 0 (not allowed!)
*: visible through a 5% ND (Neutral Density) filter
**: adjacent dots also add to the single dot counter
Note: other defects that may occur e.g. mura are subject to user interpretation and should be
evaluated individually.