Velleman GIK13 User Manual
Page 4
GIK13
02.12.2010
©Velleman nv
4
5. Operating Instructions
Refer to the illustrations on page 2 of this manual.
•
Flying insects, attracted by the UV light [A], land on the glue board placed inside the housing, get
stuck and die from dehydration.
a. Mounting
•
Determine a proper mounting location. The insect killer should be mounted in a rather dark place
at a height of about 2m (out of reach of children). The device is not suitable to be used in a
garage, stable or similar (semi-outdoor) environment.
Note: a mains outlet is required near the mounting location.
•
The GIK13 can be used freestanding or hanging from the ceiling (chains included).
•
When suspending from the ceiling, mount 2 hooks (not incl.) to the ceiling. Make sure the ceiling
is strong enough to carry the weight of the GIK13. Attach the chains to the hooks and the other
ends to the suspension points of the GIK13.
b. Glue board
•
Remove the protective cover of the glue board and slide it with the sticky side facing the UV-
lamps in the housing.
•
Replace the glue board on a regular basis. Spare glue board: GIK13GB (5 pcs).
c. Switching on/off
•
Connect the included power cable to the power socket [D].
•
Plug the other end of the cable into a suitable mains outlet to switch on the lamps.
•
To switch off the lamps, simply unplug the power cable from the mains.
d. Cleaning the device
•
Unplug the device from the mains.
•
Clean the insect killer regularly with a moist soft cloth. Do not use alcohol, abrasives or solvents.
Do not submerge into any liquid.
•
Make sure no dust accumulates on the UV lamps as this will greatly reduce their effectiveness.
e. replacing lamps and starters (refer to the illustrations on page 2)
•
When the lamp is worn, it must be replaced with a similar type (see technical specifications).
•
Unplug the device from the mains.
•
Gently rotate the lamp 90° (its pins must be lined up with the grooves on top of the fittings) and
pull the lamp upwards.
Note: it is strongly recommended to wear protective gloves when handling the lamps.
•
Insert a new lamp in the fittings and rotate it 90° to secure it.
•
To replace a starter [C], turn the starter a quarter turn anticlockwise and pull it out of the
socket. Insert a new starter with the same specifications (220-240V~, 4-22W) into the socket
and turn it a quarter turn clockwise to secure it.
•
Reconnect the device to the mains power outlet.
Dispose of worn or broken lamps in accordance with local regulations.
6. Technical specifications
input voltage
230VAC / 50Hz
effective area
100m²
dimensions
Ø195 x 555mm
weight 3.3kg
lamp
UV tube 2 x 15W (spare lamp: GIK09LAMP)
spare glue board
GIK13GB
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product, please visit our website www.perel.eu. The information in this
manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without
the prior written consent of the copyright holder.