Velleman CFAN0335 - Manual (Page 4)

CFAN0335/CFAN0342
V. 01 – 26/11/2012 4 ©Velleman nv
4. Position the rear grille [6] firmly to the motor housing [9] with the handle at the top. Make sure the pegs
on the motor housing are engaged correctly in the holes in the grille. Fasten it with the mounting nut [5].
5. Remove and discard the PVC sleeve [4] from the motor shaft [7].
6. Push the fan blade [3] along the motor shaft [7], aligning the slot at the back of the blade with the drive
pin that passes through the motor shaft.
7. Screw the spinner [2] on the motor shaft and tighten it firmly against the fan blade.
8. Hang the front grille [1] on the rear grille. Make sure the screw holes in the rims of the grilles correspond.
Fix the grilles together with the screw and the clips on the rim of the front grille.
Your fan is now ready for use.
7. Use
To use the fan:
1. Place the fan on a flat and sturdy surface. Make sure no objects (e.g. curtains) can be sucked into the rear
of the fan.
2. Insert the power plug into the mains.
3. Adjust the tilt angle by pushing the grille.
4. Set the desired output speed using the speed buttons [10]: 0 = stop; 1 = low; 2 = medium; 3 = high.
5. Push down the oscillation knob [8] to make the fan oscillate. Pull up the oscillation knob [8] to fix the fan’s
direction.
6. Always switch off and unplug from the mains before moving the fan.
7. Switch off and unplug from the mains after use.
8. Cleaning and maintenance
• Disconnect the device from the mains prior to maintenance activities.
• Clean out the parts with a soft and dry cloth. Remove stains with a damp cloth and some mild soap.
Remove soap remnants with the damp cloth. Do not use abrasives.
• Make sure no water or any other liquid enters the motor assembly [9] or the control buttons [8, 10].
• Keep the ventilation holes of the motor assembly [9] free from dust at all times.
9. Technical Specifications
CFAN0335 CFAN0342
power supply 230 Vac / 50 Hz
power 40 W 50 W
Ø fan 30 cm 40 cm
power cord length 1.5 m
airflow > 32 m³/min. > 51 m³/min.
oscillation arc 75°
height 48 cm 59 cm
weight 3100 g 2900 g
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device.
For more info concerning this product and the latest version of this manual, please visit our website
www.perel.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.