Velleman CAMIP19 - Manual (Page 3)

CAMIP19
V. 01 – 03/10/2013 3 ©Velleman nv
5. Installation: Hardware
1. Fasten the round base of the bracket to where you want to install the camera.
2. Assemble the bracket and the camera, and adjust the viewing angle of the camera.
6. Installation: Power Supply and PoE (Power over Ethernet)
Power Supply
1 8P8C network cable
2 alarm in (yellow)
3 GND (brown)
4 RESET (red)
5 GND (black)
6 alarm out (pink)
7 power cable
For your camera to work properly, you need to connect the camera cables as follows:
1. Connect the network cable [1] to your network.
2. Plug the camera’s power cable [7] in a suitable power adapter (12 Vdc 1 A, for example
PSSE1210, not incl.) and connect it to a power socket.
PoE (Power over Ethernet) Connection
The camera features PoE (Power over Ethernet). If your router or hub supports PoE, you do not need to
connect the camera to a power socket. You can then connect the camera as shown below:
8 PoE router/hub
9 LAN cable
10 camera
11 power
1. Use a network cable [9] to connect your camera [10] to a PoE port of your router [8].
2. Make sure your router is connected to a power socket [11].
Note: If your router does not support PoE, you can use a PoE injector (not included) to use the PoE
feature.
7. Software Configuration
The installation method below describes the setup with an iPhone® with a D-Link® wireless router and
modem. The installation procedure is similar for iPad® or Android™ devices. Refer to the full manual on
the included CD-ROM for more information.