Velleman CHLSC1 - Manual (Page 7)

CHLSC1
09.09.2009 ©Velleman nv 7
• Output brightness too low
Check the output connections and controller input voltage.
• Overheating of the controller
Make sure the controllers’ input voltage is not too high and check whether
there is sufficient ventilation.
• In linked mode, controllers don’t work synchronously.
Check the data terminals and the length of the data bus. Press any key on
the remote control to start synchronizing.
• Remote control is not working
Point the remote control straight towards the IR receiver, check the
distance (<7m). Replace the battery.
10. Technical specifications
input voltage 12 or 24VDC
output power 180W (12VDC) or 360W (24VDC)
max. output for each loop 60W (12VDC) or 120W (24VDC)
IR remote control working distance 7m
dimensions
Controller 121 x 51 x 26mm
IR remote control 90 x 49 x 7mm
Weight
Controller ±110gr
IR remote control
±22gr
power supply remote control 3V lithium CR2025, incl.
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulted from (incorrect) use
of this device.
For more info concerning this product, please visit our website
www.hqpower.eu .
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied, reproduced, translated or
reduced to any electronic medium or otherwise without the prior written consent of the copyright
holder.