Toner Cable AES Digital #300 328 lnput-Output Modules - Manual

328 I/O Modules
969 Horsham Road l Horsham, Pennsylvania 19044 USA l Phone: 215-675-2053 Fax: 215-675-7543 l [email protected]
Input Modules
AES Digital (#300): The AES Digital module is the most
straightforward audio solution for facilities that route AES
audio and use house sync to time audio and video sources.
The incoming AES audio sample rate should be equal to
the internal sample rate selected for the mixer (48, 96 or
192kHz). The Module Menu in the 328 mixers allows many
of the AES channel status bits, as well as the lock and
error status, to be monitored at a glance.
Channels 8 (4 Pairs)
Format AES3id 75Ω unbalanced
Sample Rates 48KHz / 96kHz / 192kHz
Precision 24 bits
AES SRC Digital (#301): The AES SRC Digital module
upgrades the standard AES Digital module with the addition
of asynchronous sample rate converters on each input pair.
This module is recommended for applications where
unlocked sources such as CD players or equipment with
varying sample rates are used. A bypass mode─accessible
in the Module Menu of the 328 mixers─allows the sample
rate converter to be bypassed for locked inputs when
desired.
Channels 8 (4 Pairs)
Format AES3id, 24 bit, 75Ω
unbalanced
Sample Rates 16kHz - 212kHz
Dynamic Range -140dBFS @ 0dBFS
(SRC active)
Analog Line (#302): Four balanced line level inputs and
high-quality Burr-Brown ADCs make this module a great
choice for analog input sources. The built-in analog gain
trims allow operating level to be reached with inputs as hot
as 28dBu to as low as -18dBu (peak). Input connections
are made on a 15-pin D-Sub connector. A rack-mount
external XLR connector bridge is available (see
Accessories) to simplify the installation process.
Channels 4 Line
Format Balanced Line Level
(DB-15 Connector)
Impedance >10kΩ
Frequency Range20—20kHz ±0.1dB
Dynamic Range >100dB
THD+N
>−90dB @ −20dBFS
(+4dBu)
Nominal Gain Range −22dBu—+10dBu
Analog w/Mic (#303): The Analog w/Mic module uses the
same high-performance circuitry as the 4 Channel Analog
Input, and adds an additional two channels of balanced mic
input on standard XLR connectors. A phantom power
switch turns on or off 48V phantom power to both inputs,
and an external LED indicator lights to warn when phantom
power is active. On-board jumpers for the pin 1 connec-
tions allow multiple grounding options and AES48 compli-
ance.
Channels 4 Line, 2 Mic
Format (Mic) Balanced XLR
Impedance >10kΩ
Frequency Range20—20kHz ±0.1dB
Dynamic Range >100dB
THD+N
>−90dB @ −20dBFS
(-30dBu)
Nominal Gain Range −62dBu—-15dBu
SD/HD SDI De-embedder (#304): The SD/HD SDI De-
embedder possesses one input and one loop-through
output BNC connector for SD/HD SDI sources. SD or HD
format is detected automatically. Any two of the four SDI
4-channel groups may be selected from the SDI embed-
ded audio stream using the Module Setup menu on the
328 Mixer display. Asynchronous sample rate converters
on the module permit unlocked SDI sources, alternate
embedded audio sampling rates, or higher audio mixer
internal sample rates to be used. The sample rate con-
verters may be bypassed if both the mixer and the SDI
signal are locked to house sync allowing support for the
pass-through of non-audio data such as Dolby E.
Channels 8 (From any 2 of groups 1-4)
Format SD or HD SDI, auto-detected
HD Serial Digital 1.485 Gb/s, SMPTE
274M, 292M, 296M
SD Serial Digital 270 Mb/s, SMPTE 259M-C
HD Standards Supported
● 1080i (SMPTE 274M -4,5,6) 50, 59.94 or 60 Hz
● 720p (SMPTE 296M -1,2,3) 50, 59.94 or 60 Hz
● 1080p (SMPTE 274M -9,10,11) 23.98, 24, 25 Hz
● 1080sF (RP211 -14,15,16) 23.98, 24, 25 Hz