Toner Cable FH-50 Series Fiber Holders for Fusion Splicing - Manual

Specifications Subject To Change Without Notice Rev 07-11 ©Toner Cable Equipment, Inc.
Fiber Optic Splicing
969 Horsham Road l Horsham, Pennsylvania 19044 USA l Phone: 215-675-2053 Fax: 215-675-7543 l [email protected]
Fiber Holders
AFL Telecommunications offers a variety of Fiber Holders to enhance your
fusion splicing efficiency. Fiber holders are available in 2, 4, 6, 8, 10, 12,
16 and 24 fibers capabilities for ribbon-fiber arrangements. Single-fiber
holders are available for both 250
μm coated fiber and 900 μm jacketed
pigtails.
Fiber Holders for FSM-11R and FSM-17R
Description Part #
FH-50-250 (250 μm coated single fiber) S013800
FH-50-900 (900 μm jacketed single fiber) S013804
FH-50-2 (2-fiber ribbon) S013808
FH-50-4 (4-fiber ribbon) S013812
Fiber Holders for FSM-11S and FSM-17S-FH
FH-50-250 (250
μm coated single fiber) S013800
FH-50-900 (900 μm jacketed single fiber) S013804
Fiber Holders for FSM-50R12
FH-50-12 (12-fiber ribbon)
S013828
FH-50-10 (10-fiber ribbon) S013824
FH-50-8 (8-fiber ribbon) S013820
FH-50-6 (6-fiber ribbon) S013816
FH-50-4 (4-fiber ribbon) S013812
FH-50-2 (2-fiber ribbon) S013808
FH-50-250 (250 μm coated single fiber) S013800
FH-50-900 (900
μm jacketed single fiber)
S013804
FODC-1
Safety container for disposing of cleaved fiber ends. Snap lid has holes for depositing
the fiber slivers. Any work place where fiber is being cleaved should have a container to
prevent dangerous glass splinters.
FS-9500 Fiber Safe Safety Kit
– Fiber-Safe™ safety kit is specifically for working safely with glass fiber
– Complete kit includes a Fiber-Safe polishing/work mat, fiber scraps trash can, splinter
removal tweezer, ten bifurcated cleaning swipes, each with a self-contained alcohol
dispensing tube, and safety glasses
Splice Technologies Fusion Splice Protection Sleeves
These splice protection sleeves are available in standard 40 or 60 mm lengths with an
after shrink diameter of 2.9 mm and accommodate fiber diameters up to 1.4 mm. The
sleeves are made with an inner EVA meltable adhesive tube. The tubes are clear so you
can inspect the fiber after shrinking.
FSS-SC40 40 mm length FSS-SC60 60 mm length