Toner Cable DRO 8000 Series C-Band Digital LNB - Manual

C-Band / KU-Band DRO LNBs
969 Horsham Road l Horsham, Pennsylvania 19044 USA l Phone: 215-675-2053 Fax: 215-675-7543 l [email protected]
Specifications Subject To Change Without Notice Rev 11-10 ©Toner Cable Equipment, Inc.
FREQUENCY BANDS AVAILABLE
Typical Service 4000A 4000B 4000C
Input Frequency (GHz) 11.70 to 12.20 12.25 to 12.75 10.95 to 11.70
L.O. Frequency (GHz) 10.75 11.30 10.00
Output Frequency (MHz) 950 to 1450 950 to 1450 950 to 1700
TYPICAL SPECIFICATIONS
Noise Figure 0.6 to 0.8 dB
depending on model number
L.O. Stability ±150 kHz to ±500 kHz
(over temperature excl offset) depending on model number
Phase Noise -65 dBc/Hz at 1kHz
(SSB) -80 dBc/Hz at 10kHz
-100 dBc/Hz at 100kHz
Input VSWR 2.2 : 1
Output VSWR 2.2 : 1
Conversion Gain 64 dB
Output P1dB 8 dBm
Power Requirements +15 to +24 V supplied through
center conductor of IF cable
Current Drain 120 mA
Input Waveguide WR75
Dimensions 85 (L) x 43 (W) x 43 (H) mm
(3.3 x 1.7 x 1.7 in)
Weight 120 g / 4.2 oz
Temperature Range -40°C to +60°C
DRO 4000 Series KU-Band Digital
FREQUENCY BANDS AVAILABLE
Typical Service 8000 8000I
Input Frequency (GHz) 3.40 to 4.20 4.50 to 4.80
L.O. Frequency (GHz) 5.15 5.95
Output Frequency (MHz) 950 to 1750 950 to 1450
TYPICAL SPECIFICATIONS
Noise Temperature 15K to 30K
depending on model number
L.O. Stability ±150 kHz to ±500 kHz
(over temperature excl offset) depending on model number
Phase Noise -65 dBc/Hz at 1kHz
(SSB) -80 dBc/Hz at 10kHz
-95 dBc/Hz at 100kHz
Input VSWR 2.0 : 1
Output VSWR 2.2 : 1
Conversion Gain 64 dB
Output P1dB 8 dBm
Power Requirements +15 to +24 V supplied through
center conductor of IF cable
Current Drain 130 mA
Input Waveguide CPR 229G
Dimensions 180 (L) x 100 (W) x 70 (H) mm
(7.1 x 4.0 x 2.8 in)
Weight 425 g / 15 oz
Temperature Range -40°C to +60°C
DRO 8000 Series C-Band Digital