Rough Country 1011 - Manual

JEEP TJ /YJ BUMPER
Thank you for choosing Rough Country
Please read instructions before beginning installation. Check the kit hardware against the parts list and product layout.
Be sure you have all needed parts and know where they go. Also please review tools needed list and make sure you
have needed tools.
If question exist we will be happy to answer any questions concerning the design, function, and cor-
rect use of this product.
The installer must verify that the mounting kit does not interfere with the factory air bag sensors, which must not be relo-
cated or modified in any way. The vehicles are bag system may not operate properly if the winch mounting kit is not
mounted in compliance with the vehicle manufacturers recommendations.
As with the addition of any aftermarket bumper, the air bag system will be affected and may hinder or delay deployment.
Take this into consideration and drive accordingly.
INSTALLATION
1. Place vehicle on a flat surface and set emergency brake.
2. Remove the front valence (sway bar cover), using a 3/8” wrench. See PHOTO 1
3. Using a T55 torx socket, remove the front bumper mounting hardware and tow hooks if equipped.
4. Using a 15mm socket remove the front stabilizer mounting bolts. (TJ ONLY)
5. If installing a winch at this time it is recommended that you install the winch to the mounting plate, before installing
the plate on the vehicle.
6. Place the supplied washers as shown in PHOTO 2 on TJ models. YJ models will not use these washers.
92101100
PHOTO 1
REMOVE THE SWAY BAR COVER ON TJ
PHOTO 2
PLACE WASHERS ON FRAME (TJ SHOWN)
Optional
Accessories:
Light Bar- #1014
Stinger #1013
D-Ring Mount-#1058
Kit Contents:
1– Mounting Plate
1– 1012Bag2 including:
4– Large Thick Washers
4- 1/2” x 1 1/2” Bolt
4– 1/2” Flat Washers
12-1/2” x 1 1/2” Button Head Bolts
4-1/2” Lock Nuts
2-10mm x 40mm Bolts
2-10mm Flat Washers
Tools Needed:
T55 Torx bit
3/8” Wrench
17mm Socket
3/4” Wrench
8mm Allen Wrench / Bit