Rough Country RC0342 - Manual

Thank you for choosing Rough Country for your suspension needs.
Please read all the instructions before beginning the installation. Check the kit hardware against the parts list. Be sure
you have all the needed parts and understand where they go.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is the easier it will roll. We strongly recommend, because of rollover possibility, that
seat belts and shoulder harnesses should be worn at all times. Avoid situations where a side rollover may occur.
Braking performance and capabilities are decreased when significantly larger/heaver tires and wheels are used. Take
this into consideration while driving.
Also, speedometer recalibration is necessary when larger tires are installed.
Do not add, alter, or fabricate any factory or after-market parts which increase vehicle height over the intended height of
the Rough Country product purchased. Mixing component brands, lifts, and/or combining body lift with suspension lifts
voids all warranties. Rough Country makes no claims regarding lifting devices and excludes any and all implied claims.
We will not be responsible for any product that is altered.
NOTICE TO DEALER AND VECHICLE OWNER
Any vehicle equipped with any Rough country product must have the “Warning to Driver” decal installed on the sun visor
or dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling character-
istics. INSTALLING DEALER—It is your responsibility to install the warning decal and to forward these installation in-
structions on too the vehicle owner for review and to be kept in the vehicle for its service life.
INSTALLATION INSTRUCTIONS
1. Park vehicle on a clean, level surface and block the
wheels for safety.
2. Raise the front (or rear if installing rear kit) of the vehi-
cle.
3. Place jack stands under the frame rails and lower the
axle onto the jack stands to remove pressure from
shackle assemblies.
4. Remove the stock bolts that secure the stock shackle
to the frame and retain stock hardware.
5. Remove the stock shackles.
6. Using the floor jack lower the axle to allow for the in-
stallation of the new lifted Rough Country shackles.
7. Install the new Rough Country shackles using the sup-
plied hardware as shown. If shackle or spring bushings
need to be replaced do so at this time. Leave hardware
loose.
8. Jack up the vehicle and remove the jack stands. Lower
the vehicle to the ground.
9. Bounce the vehicle to settle suspension. Tighten the uppers and lower bolts to 30-35 ft-lbs.
PARTS LIST
2-Assembled Shackles
1-Poly bag:
4-bolts
4-nuts
8-washers
92RC0270
REAR INSTALLATION SHOWN