Rough Country 1156 User Manual

Rough Country For the car

Advertising
background image

87-95 YJ & 97-06 TJ 1” MOTOR MOUNT KIT

Thank you for purchasing a Rough Country motor mount kit for your Jeep vehicle.

PRODUCT USE INFORMATION

We will not be responsible for any product that is altered. If question exist we will be happy to answer any questions con-
cerning the design, function, and correct use of our products.

Applications: Wrangler TJ, 1997+….2.5L, 2.4L & 4.0L Only

Wrangler YJ, 1987-1995…..2.5L, 4.0L & 4.2L Only

92115600

INSTALLATION INSTRUCTIONS

1. Place a floor jack under the bell housing with a block of wood to distribute the weight across the housing. Do not lift

the engine using the oil pan as a jack point.

2. Slowly raise the jack to slightly take the pressure off of the motor mounts.
3. Starting on the passenger side of the vehicle, remove the nut from the cross bolt that secures the rubber isolator to

the engine support bracket using a 18mm & 19mm wrench. See Photo 1.Do not remove the cross bolt at this time.

4. Remove the stock bolts and nuts that secure the mount to the frame using a 15mm wrench. Retain the factory

hardware. See Photo 2.

PREINSTALLATION NOTES

This kit will be installed on one side of the vehicle at a time.
A body lift must be installed to allow this kit to be installed.
Check OE motor mount bushings and studs to make sure they are in good operating shape. If needed new motor
mounts must be installed.

Tools Needed:
15mm Wrench
16mm Wrench
18mm Wrench
19mm Wrench
Floor Jack

Kit Content:
2-Motor Mount Spacer
2-Studs
2-10mm x 60mm bolts
2-10mm washers

Photo 1

Photo 2

Advertising