Rough Country 1065 User Manual
Rough Country For the car
1/4” WHEEL SPACER KIT FOR 6-5.5” & 6-135MM WHEEL PATTERN
Thank you for choosing Rough Country for all your suspension needs.
Professional knowledge of disassemble/reassembly procedures as well as post installation checks must be known. At-
tempts to install these wheel spacers without this knowledge and expertise may jeopardize the integrity and/or operating
safety of the vehicle.
Please read instructions before beginning installation. Also please review tools needed list and make sure you have
needed tools.
Important Note: Spacers must be periodically checked to ensure tightness.
Kit Contents:
Part #1065 Qty 2-1/4”” Wheel Spacers
92106500
Tools Needed:
Torque Wrench
Floor Jack
Jack Stands
Sockets
Socket wrench
Installation Instructions
1. Chock the tires and jack up the vehicle.
2. Remove the lug nuts and remove the tire and wheel. If retaining clips are present they must be re-
moved for the spacer to sit flat on the rotor surface. Note: Failure to remove the factory retaining clips on the
wheel studs could result in a wheel /tire vibration.
3. Install the wheel spacers as shown. See Photo 1.
4. Reinstall the wheels and tighten the lug nuts to manufacturer specifications . DO NOT EXCEED MANUFACTURER
SPECIFICATIONS.
Post Installation
• Wheels must be re-torqued periodically. Visually inspect components and re torque
fasteners during routine vehicle service.
Photo 1