Rough Country 489P - Manual

Thank you for choosing Rough Country for your suspension needs .
Rough Country recommends a certified technician installs this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read all the instructions before beginning the installation. Check the kit hardware against the parts list on the
back page of these instructions. Be sure you have all the needed parts and understand where they go. Also please re-
view the tools needed list and make sure you have needed tools.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is the easier it will roll. Seat belts and shoulder harnesses should be worn at all
times. Avoid situations where a side rollover may occur. Braking performance and capabilities are decreased when sig-
nificantly larger/heaver tires and wheels are used. Take this into consideration while driving. Also, speedometer recali-
bration is necessary when larger tires are installed.
Do no add, alter, or fabricate any factory or after-market parts which increase vehicle height over the intended height of
the Rough Country product purchased. Mixing component brands, lifts, and/or combining body lift with suspension lifts
voids all warranties. Rough Country makes no claims regarding lifting devices and excludes any and all implied claims.
We will not be responsible for any product that is altered.
This kit with its new heavy duty track bar only fits trucks produced after 03/01/99—2000 models forward. If you
have a truck produced prior to this date this kit will not fit the vehicle. A difference of bolt size on the stock track
bar bracket does not allow the installation of the new track rod.
If the vehicle has a tool box in the rear or any other reason that the rear may be lower then normal this lift may not result
in a level look most often desired. Rough Country offers block and u-bolt combinations and add-a-leafs to raise the rear
of this vehicle to a look that is more desirable —contact you local distributor for details.
This kit was designed for use with a 305/70R-16 tire on a factory wheel. Any other variation will need to be verified be-
fore use to prevent possible clearance issues.
If you have any questions about this installation or the product included please call our customer service department at
800-222-7023.
NOTICE TO DEALER AND VECHICLE OWNER
Any vehicle equipped with any Rough country product must have the “Warning to Driver” decal installed on the sun visor
or dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling character-
istics. INSTALLING DEALER—It is your responsibility to install the warning decal and to forward these installation in-
structions on too the vehicle owner for review and to be kept in the vehicle for its service life.
SUPER DUTY 2.5” LEVELING KIT
92148900R1
INSTALLATION INSTRUCTIONS
1. Place the vehicle in park. Block the rear wheels and
jack up the front of the vehicle. Secure with jack
stands behind the spring shackle on the frame rail.
2. Lightly support the front axle assembly with a floor
jack.
3. Remove the tires/wheels.
4. Remove the front shock absorbers.
5. Remove the 4 nuts on the front bumper holding the
front bumper to the frame using a 18mm socket and
the rear bumper support bolts (1 each side) on the
frame bracket as shown in Figure 1 using a 15mm
socket.
Figure 1