Rough Country 397 - Manual

05 & 10 2WD Dakota & Mitsubishi Raider
Thank you for choosing Rough Country for all your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known.
Please read instructions before beginning installation. Check the kit hardware against the kit contents list on the back
page. Be sure you have all needed parts and know where they go. Also please review tools needed list and make sure
you have needed tools.
PRIOR TO INSTALLTION NOTE:
Under hard acceleration in 4x4 high, stock Dodge Ram’s often have a front end vibration or shutter. This vibra-
tion or shutter exist due to the design of the motor and differential mounts and is inherent in the vehicle. This
vibration or shutter may be more pronounced after a leveling kit is installed due to additional torque from modi-
fied driveshaft angles. This does not indicate a problem, but should be a consideration prior to installation
.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is, the easier it will roll. Seat belts and shoulder harnesses should be worn at all
times. Avoid situations where a side rollover may occur.
Generally, braking performance and capability are decreased when larger/heavier tires and wheels are used. Do not
add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height of the Rough
Country product purchased.
Rough Country makes no claims regarding lifting devices and excludes any and all implied
claims. We will not be responsible for any product that is altered. If question exist we will be happy to answer any ques-
tions concerning the design, function, and use of our products.
This suspension system was developed using a 33X12.50/17, tire with factory wheels.
NOTICE TO DEALER AND VEHICLE OWNER
Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. And should act as a constant reminder of its unique handling characteristics.
INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation instructions on
to the vehicle owner for review. These instructions should be kept in the vehicle for its service life.
92397000
INSTALLATION INSTRUCTIONS
1. Jack up the front of the vehicle and support the vehicle with jack stands, so that the front wheels are off the ground .
2. Using 22mm socket remove the front tires/wheels.
3. Using 21mm socket remove the nut from the steering linkage. Using a hammer hit on the side of the knuckle as
shown, and remove the linkage from the knuckle. Push linkage forward to make room for installation. Retain factory
hardware See PHOTO 1.
4. Using a 15mm wrench, remove the sway bar nut, and bushings allowing the sway bar to drop. Retain factory hard-
ware. See PHOTO 2.
PHOTO PHOTO 2