Rough Country 87319 - Manual

JEEP JK 2.2 SERIES STABILIZER KIT
Thank you for choosing Rough Country for your suspension needs.
Rough Country recommends a certified technician installs this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read all the instructions before beginning the installation. Check the kit hardware against the parts list. Be sure
you have all the needed parts and understand where they go. Also please review the tools needed list and make sure
you have needed tools.
Note: This kit can easily be upgraded to a dual unit with the addition of part number 87318.
NOTE: THIS STABILIZER IS FOR USE WITH VEHICLES LIFTED 2 1/2”-6”. INSTALLING THIS STABILIZER ON AN
UNLIFTED VEHICLE IS NOT RECOMMNENDED.
82271
KIT CONTENTS:
1-Center Axle bracket
1-Tie rod brackets
1-Stabilizer Cylinders
1-Center Cover Bracket
1—Kit Bag Containing
2—½” x 2½” Bolt
1—½” x 1 Bolt
3—½” Nuts
2—½” Washers
2— ⅜” 1 ½” x 2 3/16” U-bolts
2— ⅜” x 2 ½” x 3 1/4” U-bolts
8— ⅜” Flanged Locknuts
1— Stabilizer Sleeve
TOOLS NEEDED:
9/16” Wrench
3/4” Wrench TORQUE SPECS:
⅜”
30 ft/lbs - 35 ft/lbs
½” 65 ft/lbs - 75 ft/lbs
2.2 Series Stabilizer
Center Axle
Bracket
Tie Rod
Bracket
Axle U-Bolts (2)
Tie Rod U-Bolts (2)
Stabilizer Mounting Hardware RCX Center Cover