Rough Country 9285 - Manual

Page 1
Thank you for choosing Rough Country Off Road Gear for your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to
install this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the
vehicle.
Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you
have all needed parts and know where they go.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is, the easier it will roll. Offset, as much as possible, what is lost in rollover
resistance by increasing tire track width. In other words, go "wide" as you go "tall".
Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height
of the Rough Country product purchased. Mixing component brands, lifts, and/or combining body lift with
suspension lifts voids all warranties. Rough Country makes no claims regarding lifting devices and excludes any
and all implied claims. We will not be responsible for any product that is altered.
Braking performance and capability are decreased when significantly larger/heavier tires and wheels are used.
Take this into consideration while driving.
The required installation time for this system is approximately ½ - 1 hour (see recommended tool list shown
below).
This suspension system was developed using a 33 x 12.50R – 17 and 18” tires, on a 8 ” wheel. Before installing
other combinations, please consult your local tire and wheel specialist.
The 1.5 ” -2 ” front leveling system comes standard with nothing for the rear. Personal preference, OE options, and
aftermarket add-ons may affect the amount of desired lift in the rear and this package can/may have been altered
to accommodate individual needs.
If questions exist we will be happy to answer any questions concerning the design, function, and correct use of our
products.
NOTICE TO DEALER AND VEHICLE OWNER
Any vehicle equipped with any Rough Country product should have a “ Warning to Driver ” decal installed on the
inside of the windshield or on the vehicle ’ s dash. The decal should act as a constant reminder for whoever is
operating the vehicle of its unique handling characteristics.
INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation
instructions on to the vehicle owner for review. These instructions should be kept in the vehicle for its service life.
RECOMMENDED TOOLS
 Floor jack
 Heavy duty jack stands
 Safety glasses
 Wheel chocks
 ½”
Socket
 10mm deep well socket
 18mm deep well socket
 21mm deep well socket
KIT COMPONENTS
9285 -progressive rate front coil springs Options: Block and U-Bolt Kit ,
Premium Nitro Shocks
Fox Shox
91928500
FORD SUPERDUTY
Leveling Lift System