Rough Country RC610 - Manual (Page 3)

INSTALLATION INSTRUCTIONS
1. Disconnect the negative battery cable using 1/2 wrench.
2. Remove plastic jeep cover from front of vehicle using 3/8 wrench and metal plate that also hold brake line.
3. Disconnect air intake from air filter housing and from throttle body. Depending on year remove power steering reser-
voir from fan shroud. Use a 13mm wrench.
4. (AUTO TRANSMISSION ONLY) Remove the linkage on the frame to allow the body to be moved up by removing
the two bolts and remove the cotter pin securing it to the engine bracket. Allowing the shifter cross shaft to hang
freely. Retain hardware for reuse. See Photo 1
5. Remove the 4 bolts from radiator shroud using 13mm socket. See Photo 2.
6. Unplug vacuum hose from brake booster. See Photo 3.
7. Mark the steering shaft and take apart using 1/2 socket on both upper and lower parts of shaft. See Photo 4 & 5.
8. Remove hard brake lines from hold down clips on frame just below master cylinder.
9. Remove gas cap and remove the bolts that attach the fuel filler hose to the plastic fuel filler bezel using a 8mm
socket. See Photo 6. Be sure to push the filler hose back in the hole to avoid it hanging when jacking up the body.
Photo 2
Photo 3 Photo 4
Photo 5 Photo 6
Remove the radiator shroud bolts
Remove the booster line Mark the steering shaft
Remove the steering shaft bolts Remove the filler neck from the body
Photo 1
AUTO ONLY—REMOVE SHIFTER BRACKET