Rough Country 664 User Manual

Up jeep commander 2” lift kit

Advertising
background image

06-UP JEEP COMMANDER 2” LIFT KIT

Thank you for choosing Rough Country for all your suspension needs.


Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.

Please read instructions before beginning installation. Check the kit hardware against the parts list on this page. Be sure
you have all needed parts and know where they go. Also please review tools needed list and make sure you have
needed tools.

PRODUCT USE INFORMATION

As a general rule, the taller a vehicle is, the easier it will roll. Seat belts and shoulder harnesses should be worn at all
times. Avoid situations where a side rollover may occur.

Generally, braking performance and capability are decreased when larger/heavier tires and wheels are used. Take this
into consideration while driving. Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height
over the intended height of the Rough Country product purchased. Mixing component brands is not recommended.

Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be re-
sponsible for any product that is altered.

If questions exist we will be happy to answer any questions concerning the design, function, and correct use of our prod-
ucts.

This suspension system was developed using a 265/70R-17 tire with factory wheels. Note if wider tires are used, offset
wheels will be required and trimming will be required.

NOTICE TO DEALER AND VEHICLE OWNER

Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehi-
cle of its unique handling characteristics.

INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation instructions on
to the vehicle owner for review. These instructions should be kept in the vehicle for its service

Kit Contents:

664 Kit Box
2– Front Coil Spring Spacers
2– Rear Coil Spring Spacers
1-Poly Bag

9266400

Tools Needed:

10mm Wrench
14mm Socket
16mm Wrench
16mm Socket
18mm Wrench
18mm Socket
19mm Deep Well Socket
Jack
Jack Stands
Hand Grinder
Strut Compressor

Torque Specs:

Size Grade 5 Grade 8
5/16” 15 ft/lbs 20 ft/lbs
3/8” 30 ft/lbs 35 ft/lbs
7/16” 45 ft/lbs 60 ft/lbs
1/2” 65 ft/lbs 90 ft/lbs
9/16” 95 ft/lbs 130 ft/lbs
5/8” 135 ft/lbs 175 ft/lbs
3/4” 185 ft/lbs 280 ft/lbs

Class 8.8

Class 10.9

6MM

5 ft/lbs

9 ft/lbs

8MM 18ft/lbs

23

ft/lbs

10MM 32ft/lbs

45ft/lbs

12MM 55ft/lbs

75ft/lbs

14MM 85ft/lbs

120ft/lbs

16MM 130ft/lbs

165ft/lbs

18MM 170ft/lbs

240ft/lbs

Advertising