Rough Country 776 - Manual

JEEP JK SWAY BAR SKID
Thank you for choosing Rough Country for your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you have all
needed parts and know where they go. Also please review tools needed list and make sure you have needed tools.
PRODUCT USE INFORMATION
Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be re-
sponsible for any product that is altered.
If question exist we will be happy to answer any questions concerning the design, function, and correct use of our prod-
ucts by calling 1-800-222-7023.
This JK sway bar skid is designed to work with any JK.
Kit Picture
Tools Needed
9/16” Socket
15mm Socket
16mm Socket
17mm Socket
13/32” drill bit
Install Instructions
1. Park the jeep on a flat level surface.
2. Remove the passenger side sway bar bracket bolts with a 16mm socket. See Photo 1.
3. Locate the mounting bolt for the disconnect motor and remove with a 15mm wrench. See Photo 2. Only Rubicon
model JK’s will have the electric disconnect motor, all other models will skip these steps for the disconnect motor.
92776000
Photo 1 Photo 2 PHOTO 1 PHOTO 2