Rough Country 207 - Manual (Page 2)

Tools Needed:
18mm Wrench
15mm Socket
15mm Wrench
17mm Wrench
21mm Wrench
7/32 Allen Wrench
Flat Screwdriver
Hammer
INSTALLATION INSTRUCTIONS
1. Jack up the front of the vehicle and support the vehicle with jack stands, so that the front wheels are off the ground
2. Remove the front tires/wheels., using a 7/8” deep well socket
3. Using a 18mm wrench loosen the upper strut bolts. Do not remove at this time. See Photo 1.
4. Place jack stand under the knuckle for support. Remove upper ball joint nut, using a 18mm wrench. Using a ham-
mer hit the knuckle as shown to allow the ball joint to separate from the knuckle. See Photo 2. Do not allow the
knuckle to pull out far enough that it pulls the shaft out of the differential.
5. Using a 21mm wrench remove the nut from the steering linkage. Using a hammer hit on the side of the knuckle as
shown, where the steering linkage is connected and remove from knuckle. Push linkage forward to make room for
installation. Retain factory hardware. See Photo 3.
6. Remove the sway bar nut and bushings using a 15mm wrench, and 15mm socket. Retain factory hardware. See
Photo 4
Photo 1 Photo 2
Photo 3 Photo 4
Kit Contents:
2- Lower Strut Extensions
2– Upper strut spacers
2– 3/4” Rear Coil Spacers
1307 Kit Bag
4-10x1.5x80mm bolts
8-SAE Flat washers
4-10mm nuts
1308 Kit Bag
4-10x1.5x90mm bolts
8-SAE Flat washers
4-10mm nuts