Rough Country 750S - Manual

Thank you for choosing Rough Country for all your suspension needs.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is, the easier it will roll. Offset, as much as possible, what is lost in rollover resis-
tance by increasing tire track width. In other words, go "wide" as you go "tall". Many sportsmen remove their mud tires
after hunting season and install ones more appropriate for street driving; always use as wide a tire and wheel combina-
tion as possible to enhance vehicle stability.
Seat belts and shoulder harnesses should be worn at all times. Avoid situations where a side rollover may occur
Generally, braking performance and capability are decreased when significantly larger/heavier tires and wheels are
used. Take this into consideration while driving.
Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height of the
Rough Country product purchased. Mixing component brands is not recommended.
Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be re-
sponsible for any product that is altered.
If questions exist concerning the design, function, and correct use of our products we will be happy to answer these
questions.
NOTICE TO DEALER AND VEHICLE OWNER
Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehi-
cle of its unique handling characteristics.
INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation instructions on
to the vehicle owner for review. These instructions should be kept in the vehicle for its service.
99-06 TUNDRA 2.5” KIT
92175000REV1
Kit Contents:
2-Front Strut Extensions
2-2” Rear Blocks
2-Rear Shock Absorbers
4-Rear U-bolts
1-Wiring Loom Bracket
1-Proportiong Valve Bracket
1-Kit Bag that includes
6-3/8”
studs
6-3/8” nuts
6-3/8” lock washers
3-5/16” x 1” bolts
3-lock nuts
1-Shock bag
Tools Needed:
Assorted Metric wrenches
Assorted Metric sockets
Floor Jack
Jack stands
Hammer