Rough Country 674X - Manual (Page 7)

26. Mark the holes to be drilled and remove the bracket from the frame. See Photo 14.
27. Drill the two holes per side using a 17/64” drill bit. See Photo 15. Be sure to only drill through the outside of the
frame rail.
28. Install the frame bracket with the supplied 5/16” self tapping bolts (2 per bracket) using a 1/2” wrench as shown in
Photo 16.
29. Install the supplied mounting pin as shown in Photo 17 and tighten using 19mm socket / wrench.
30. Swing the new sway bar link down and secure on the mounting pin using the supplied quick disconnect pin. See
Photo 18.
Photo 16
Tighten 5/16” self tapping bolts
Photo 14 Photo 15
Center punch holes Drill Holes using a 17/64” drill bit
Install mounting pin on the axle
Photo 17
Link shown installed on pin
Photo 18