Rough Country 1328BOX4 - Manual

Thank you for choosing Rough Country for all your suspension needs.
In addition to these instructions, professional knowledge of disassemble/reassembly procedures as well as post installa-
tion checks must be known. Attempts to install this system without this knowledge and expertise may jeopardize the
integrity and/or operating safety of the vehicle. Be sure you have all needed parts and know where they go. Also please
review tools needed list and make sure you have the tools needed to install the kit.
NOTICE TO DEALER AND VEHICLE OWNER
Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehi-
cle of its unique handling characteristics.
INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation instructions on
to the vehicle owner for review. These instructions should be kept in the vehicle for its service life.
921328BOX4
06-10 DODGE KICKER BAR KIT
19mm Socket/ Wrench
1/2” Drill Bit
Drill Motor
Tools Needed:
Size Grade 5 Grade 8
1/2” 65 ft/lbs 90 ft/lbs
Torque Specs:
INSTALLATION INSTRUCTIONS
1. Install the supplied kicker bar brackets using the supplied 1/2” x 1 1/2” bolts, washers and nuts to the rear cross-
member on the driver and passenger side. Note: Make sure the brackets are straight as shown. Tighten using a
19mm socket / wrench. See Photo 1.
2. Install supplied bushings and sleeves in kicker arms and install in the brackets on the driver and passenger side with
the supplied 1/2” x 3 1/2” bolts, washers and nuts. Do not tighten at this time. See Photo 2.
PHOTO 1 PHOTO 2
INSTALL BRACKETS ON CROSS-MEMBER INSTALL KICKER BARS IN BRACKETS