Rough Country 1089 - Manual

JEEP REAR BAR PIN ELIMINATOR KIT
INSTALLATION INSTRUCTIONS
1. After the rear shock absorber has been removed from the rear upper mount. Install the bar pin bracket as
shown in the stock location with the stock hardware as shown in Photo 1.Tighten using a 13mm wrench.
2. Install the shock absorber on the bar pin bracket with the supplied 1/2” x 2 1/2” bolt and lock nut as shown in
Photo 2. Tighten using a 3/4” wrench & socket.
92108900
Thank you for choosing Rough Country for your Jeep off road needs.
Please read all the instructions before beginning the installation.
PRODUCT USE INFORMATION
We will be happy to answer any questions regarding our products by calling us @ 800-222-7023. Rough Country
will not be responsible for any product that is altered.
KIT CONTENTS
2-REAR UPPER SHOCK BRACKETS
1-POLY BAG CONTAINING:
2-SHOCK
SLEEVES
2-1/2” X 2 1/2” BOLTS
2-1/2” LOCK NUTS
TOOLS NEEDED
13MM WRENCH
3/4” WRENCH /SOCKET
POST INSTALLATION
1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating,
mobile, fixed and heated members. Check steering for interference and proper working order.
2. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine
vehicle service.
Photo 1 Photo 2