Rough Country PERF619 - Manual (Page 14)

80.Install the track rod on the axle with the supplied 7/16” x 2 3/4”mm bolt, washer & nut. Do not tighten at this time.
See Photo 48.
81.Swing up the track rod and adjust as necessary to center the vehicle over the axle and install in the new track rod
bracket with the supplied 12mm X 80mm bolt and flange nut. Tighten to 55 ft/lbs using a 15mm wrench and snug
the jam nut using a 1 1/2” wrench. See Photo 49. It is important to center the vehicle over the axle to ensure
proper tracking and alignment.
82. Install the rear track rod on the axle and tighten with factory hardware
83. Assemble the new sway bar links with the supplied 10mm sleeves.
84. Install the new sway bar links on the sway bar with the supplied 10mm x 60mm bolts, washers and lock nuts. See
Photo 50.
85. Install the sway bar link on the frame using the stock flag nuts and the supplied 10mm x 60mm bolts and wash-
ers. See Photo 51.
PHOTO 48
Install 7/16” x 2 3/4” bolt Install 12mm X 80mm bolt, washer & nut
PHOTO 49
PHOTO 50 PHOTO 51
Install the 10mm x 60mm bolt, washer & lock nut Install 10mm x 60mm bolt with stock flag nut