Rough Country 234N2 User Manual

Rough Country For the car

Advertising
background image

92123400

99-06 2WD CHEVY/GM 1500 6” LIFT

Thank you for choosing Rough Country for all of your suspension needs.
Rough Country recommends a certified technician installs this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.

Please read all the instructions before beginning the installation. Check the kit hardware against the Kit Contents list on
next page. Be sure you have all the needed parts and understand where they go. Also please review the tools needed
list to be certain that you have the tools necessary to complete the installation.

PRODUCT USE INFORMATION

As a general rule, the taller a vehicle is the easier it will roll. We strongly recommend that seat belts and shoulder har-
nesses should be worn at all times. Braking performance and capabilities are decreased when significantly larger/
heavier tires and wheels are used. Do no add, alter, or fabricate any factory or after-market parts which increase vehicle
height over the intended height of the Rough Country product purchased. Rough Country makes no claims regarding
lifting devices and excludes any and all implied claims. We will not be responsible for any product that is altered.

Due to differences in manufacturing, dimension and inflated measurements, tire and wheel combinations should be test
fit prior to installation. This kit was developed using a 35.12.0-16 on stock wheel.

NOTICE TO DEALER AND VEHICLE OWNER

Any vehicle equipped with any Rough country product must have the “Warning to Driver” decal installed on the sun visor
or dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling character-
istics. INSTALLING DEALER—It is your responsibility to install the warning decal and to forward these installation in-
structions on too the vehicle owner for review and to be kept in the vehicle for its service life.

Kit Contents:

1285:
1-Dr Side Knuckle
1-Pass Side Knuckle

1234BOX1:
Front Cross-member
Rear Cross-member
Fr Coil Spacers (2)
Fr Sway Bar Brkt (4)
Fr Sway Bar Link (2)
Sway Bar Link Bag
Coil Spacer Template

1234BOX2:
658723 Fr Shock (2)
658727 Rr Shock (2)
Fr Shock Bag (2)
Rear Fabbed Block(2)
Rear U-bolts
9/16” Nut U-bolt Bag

Bag Contents:

1234Bag2:
For Cross-Members
5/8” X 4 1/2” Bolt (2)
5/8” x 5 1/2” Bolt (2)
5/8” Lock Nut (4)

1234Bag3:
For Front Spacers:
3/8” Lock Nut (8)
1/2” Lock Nut (2)
1/2” Flat Washer (2)

LinkBag1:
For Fr Sway Bar Links
12MM X 65MM Bolts (4)
12mm X 35MM Bolts (4)
12MM Flange Nuts (8)

Advertising