Rough Country 87495.20 - Manual

INSTALLATION INSTRUCTIONS
FORM NO. 82239
1. Remove original equipment steering stabilizer from the Passenger side mount and the tie rod.
3. On drivers side secure with supplied ½” & 7/16” hardware .The supplied 7/16” bolt / flag nut is
used as shown in Photo 4. Repeat for Passenger side as shown in Photo 5 and secure with
supplied 7/16” hardware for the stock mounting location and ½” for the lower drilled hole.
4.
Locate and install the new center bracket as shown in Photo 6 using the supplied ½” bolt /
hardware through the stock stabilizer mounting location and 3/8” u-bolts on 02-07 models . If the
factory hole is not present in the tie rod the 1/2” bolt will not be used. Make sure bracket is
2. Locate the new driver side stabilizer bracket. Align top hole and hold in place with clamp as
shown in Photo 1. Mark as shown with ½” transfer punch and drill hole using a ½” drill bit as
shown in Photo 2 & 3. Repeat on passenger side.
PHOTO 1 PHOTO 2
PHOTO 3 PHOTO 4
PHOTO 5 PHOTO 6