Rough Country 87321.20 - Manual

Form # 82249 INSTALLATION INSTRUCTIONS
NOTE: All surfaces should be clean and dry before attaching brackets
1. Place wheels in straight forward position.
2. Place axle bracket “A” on the bottom of the axle centered between the two expanded parts of the
axle. Install the u-bolts using the lock washers and nuts. Do not tighten yet.
3. Attach mounting pin kits to the rod end of the cylinder as shown in the picture.
4. Loosely attach stabilizer bracket “B” to the tie rod as shown on the passenger side and then on the
driver side using the u-bolts and flange lock nuts.
5. Attach the rod end of the cylinders to the axle bracket “A” using lock washers and nuts.
6. Attach the barrel end of the cylinder to the tie rod brackets “B” using the bushing stack up
instructions printed on the bag.
7. Extend cylinders 4 ½” and tighten the tie rod brackets. The amount of actual piston showing should
be 4 ½”. Tighten all nuts securely on u-bolts.
8. Turn wheels fully to the right and left, making sure that no interference occurs and that wheel stops
are contacted. Adjust tie rod brackets if necessary to obtain full cylinder travel.
9. Recheck all nuts and fasteners before releasing installation.
A
B
BOX CONTENTS
TWO CYLINDERS
TWO BRACKETS (TIE ROD)
ONE AXLE BRACKET
ONE INSTRUCTION SHEET
POLY BAG 1
2 U-BOLTS
4 LOCK WASHERS
4 HEX NUTS
POLY BAG 2
4 STEM BUSHINGS
4 CUP WASHERS
2 HEX NUTS
2 PAL NUTS
8 FLANGE LOCKNUTS
4 U-BOLTS
CAUTION: Any and all warranties including but not limited to any express warranties, implied warranty of
merchantability, or implied warranty of fitness for a particular purpose shall not apply to any product altered in any way
outside the premises of the manufacturer or to any product which is not installed in accordance with the written instructions
provided by the manufacturer for installation of the product.