Rough Country 1131 - Manual

WJ JEEP FRONT QUICK DISCONNECT KIT
Thank you for choosing Rough Country for all your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Please read in-
structions before beginning installation. Check the kit hardware against the kit content list. Also please review tools
needed list and make sure you have the necessary tools to install this kit.
PRODUCT USE INFORMATION
This disconnect kit was designed to work with vehicles equipped with 3-6” of lift. Do NOT attempt to install on
stock un-lifted vehicle or vehicle equipped with more than 6” of lift.
Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height of the
Rough Country product purchased. Mixing component brands is not recommended.
With the installation of all lift kits and larger tires it is important to check the condition of your steering stabilizer. If the
stabilizer is worn or is leaking it should be replaced. Steering stabilizers are designed to restrain “bump steer” and front-
end vibration, giving added life to tires, ball joints, and other steering components. A large bore off-road stabilizer kit is
highly recommended for vehicles equipped with larger tires, please contact your Rough Country distributor for details.
We hope installing your Rough Country kit is a positive experience. If you are uncertain about some aspect of
the installation process, please feel free to call our tech support department at 800-222-7023. We do not recom-
mend that you modify the Rough Country parts in any way as this will void any warranty expressed or implied.
92113100
Tools Needed:
15mm Socket / Wrench
18mm Socket / Wrench
19mm Socket / Wrench
5/8” Wrench
Torque Specs:
Size Grade 5 Grade 8
7/16” 45 ft/lbs 60 ft/lbs
1/2” 65 ft/lbs 90 ft/lbs
9/16” 95 ft/lbs 130 ft/lbs
Class 8.8 Class 10.9
12MM 55ft/lbs 75ft/lbs
Kit Contents:
2-Front Sway Bar Links
2-Frame Brackets
For Front Sway Bar Disconnects:
2-1/2” Lock nuts
2-Hitch Pins
2-1/2” Flat washers
2-Disconnect Mounting Pins
2-12mm Flange Lock Nuts
2-12mm Jam Nuts
2-Rod Ends
2-Crush Sleeves
2-Frame Brackets