Banks Power Dodge Trucks: (Diesel ’94 - 98 5.9L Cummins) Intake- Ram-Air Intake System '98-02 User Manual
Page 6
6
96491 v.3.0
: The Banks Ram-Air
Filter comes pre-oiled and no oiling
is necessary for initial installation.
Service the filter as specified in the
Filter Maintenance Section of this
manual.
Use the Bill of Materials Chart and
the General Assembly Drawing to
reference component nomenclature
and location. Use caution when
working in the engine compartment.
Make sure the engine has been OFF
for several hours and cool.
You are about to install the Banks
Ram-Air Intake System. Read and
follow all steps before working on the
vehicle. Some components from the
stock air intake system will remain
in service. Take care when removing
stock air intake components to not
damage them.
1.
Loosen hose clamp on stock intake
tube at turbo charger compressor
connection. See figure 2
2.
Unclamp stock airfilter lid and
remove lid and tube from vehicle.
See figures 2,3
3.
Remove air filter.
4.
Loosen the 3 plastic retaining nuts
and remove stock airfilter housing
from vehicle. See figure 4
5.
connect edge grip seal (item 6)
onto Banks Filter Housing (item 1). See
Figure 5.
6.
Install Banks Filter Housing (Item
1) into vehicle using the supplied
washers and 6mm lock-nuts (Items
9,10).
7.
Install the hose (Item 5) and
two hose clamps (Item 7) onto the
Banks intake tube (Item 3) where
it will attach to the turbocharger
compressor.
Section 2
RAM-AIR INSTALLATION
Figure 2- Removal of Stock intake