Banks Power Ford Trucks: (Gas ’09 - 12 F-150 5.0, 5.4 & 6.2L) Exhaust- Monster Exhaust, Single Passenger side exit '09-10 F-150 5.4L SuperCrew Cab & F-150 Raptor 6.2L SuperCab - Manual (Page 7)

96307 v.7.0
7
12.
With the exhaust positioned
properly, begin to tighten the clamps
and hardware starting with the ones
closest to the front of the vehicle and
working your way back. Torque the
exhaust clamps evenly to 35 ft-lbs.
Make sure that each slip is fully
inserted (+/- 1 ⁄
4
”). Torque the factory
M8 hardware to 22 ft-lbs.
13.
Remove the protective covering
from the tailpipe tip.
CAUTION: The protective covering
may ignite and burn if not
removed prior to running the
engine.
14.
Your system includes two (2)
“Banks Power” logos designed to
complement the Ford emblems on
the vehicles front fenders. Use the
provided measurements for a clean
factory look (see Figure 7).
15.
Re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections
to prevent disengagement is
recommended. The Banks Monster
Exhaust installation is now complete.
Figure 6