Banks Power Dodge Trucks: (Diesel ’07 - 12 6.7L Cummins) Intake- Techni-Cooler Charge Air Cooler '07-08 - Manual (Page 2)

Dear Customer,
If you have any questions
concerning the installation of
your Banks Techni-Cooler, please
call our Technical Service Hotline
at (888) 839-2700 between 7:00
am and 5:00 pm (PT). If you have
any questions relating to shipping
or billing, please contact our
Customer Service Department at
(888) 839-5600.
Thank you.
1.
Before starting work, familiarize
yourself with the installation procedure
by reading all of the instructions.
2.
Throughout this manual, the
left side of the vehicle refers to the
driver’s side, and the right side to the
passenger’s side.
3.
Disconnect the negative (ground)
cable from the battery (or batteries, if
there are two) before beginning work.
4.
Route and tie wires and hoses a
minimum of 6” away from exhaust
heat, moving parts and sharp
edges. clearance of 8” or more is
recommended where possible.
5.
When raising the vehicle, support
it on properly weight-rated safety
stands, ramps or a commercial hoist.
Follow the manufacturer’s safety
precautions. take care to balance the
vehicle to prevent it from slipping or
falling. When using ramps, be sure the
front wheels are centered squarely on
the topsides. when raising the front
of the vehicle, put the transmission in
park (automatic) or reverse (manual),
set the parking brake, and block the
rear wheels. when raising the back of
the vehicle, be sure the vehicle is on
level ground and the front wheels are
blocked securely.
Caution! Do not use floor jacks
to support the vehicle while
working under it. Do not raise
the vehicle onto concrete blocks,
masonry or any other item not
intended specifically for this use.
6.
During installation, keep the work
area clean. Do not allow anything to
be dropped into intake, exhaust, or
lubrication system components while
performing the installation, as foreign
objects will cause immediate engine
damage upon start-up.
Tools Required:
• Drive ratchet
• Ratchet extensions
• Inch and metric deep sockets
• Torx & Allen bits
• Flat blade screwdriver
Highly recommended tools:
• Torque wrench
• Silicon lubricating spray
Warning
Technicooler is not
compatible with the A/C
condenser with the round
end tanks. See Figure 1.
General Installation Practices
2
96787 v.4.0