Banks Power Ford Motorhomes: (Gas ’05 - 14 6.8L V-10, Class-A (30-valve) Power Systems- PowerPack, Stinger & TorqueTube systems, (Class-A) '05-12 - Manual (Page 12)

12
96377 v.7.0
12.
Attach a 3.5” clamp to the
universal hanger. Put the universal
hanger onto the tailpipe. For the
universal hanger, find a suitable hole in
the frame rail directly over the tailpipe.
Using the 3 ⁄
8
” hardware, support the
universal hanger and tailpipe assembly
level to the storage boxes.
13.
Install the 5” dual wall tip onto
the tailpipe outlet. Adjust the tip such
that is a minimum of a 1-inch below
the storage boxes. Be sure drainhole is
facing down.
14.
With the exhaust postioned
properly, begin to tighen the clamps
starting with the ones closest to the
front of the vehicle and working your
way back. Torque the 3 ⁄
8
” hardware
and exhaust clamps evenly to 35 ft-lbs.
Make sure that each slip is fully inserted
(+/- 1 ⁄
4
”). All hanger pins should be
facing forward (see Figure 8). Remove
the protective covering from the
tailpipe tip.
CAUTION: The protective covering
may ignite and burn if not removed
prior to running the engine.
15.
Your system includes two (2)
Banks Power logos that can be placed
on the front passenger and driverside
panels in front of the front tires.
16.
Re-connect negative battery
cable(s). Start the engine and listen
for exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack-welding slip connections
to prevent disengagement is
recommended.
-enD, SectIon 2-
Figure 8