Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Power Systems- Stinger system '03-04 - Manual (Page 16)

DYNAFACT
Instrumentation
Installation
57.
choose a suitable location
under the lower edge of the dash
for the mounting of the instrument
panel provided where the driver can
conveniently view it.
Note: Molded pillar mount and
additional gauges are available
through Gale Banks Engineering.
58.
Using the panel as a template,
drill two 3⁄16” diameter holes in the
dash and mount the panel with the
supplied machine screws, nuts and
star washers provided.
59.
Locate the supplied gauge wire
harness with the 4-pin connector.
Plug the 4-pin connector into the
corresponding 4-pin receptacle from
the EconoMind wire harness. See
Figure 3.
60.
Install the DynaFact boost
and pyrometer gauges in the
mounting panel using the clamps and
thumbnuts provided. Plug the BLAck
wire lead to the male spade terminal
on the BLAck wire of each gauge
wire harness. Plug the YELLOW wire
into the Yellow wire of the boost
gauge wire harness and the RED wire
into the RED wire of the pyrometer
gauge wire harness. The ORANGE
wire remains unused.
61.
connect the 4-pin connector
of each gauge into the back of its
corresponding gauge.
a. crimp the remaining Black and
RED wires from each 4-pin
connector gauge harness to the
butt connectors as shown in Figure
21.
b. Strip one end of the RED wire
and crimp to one of the butt
connectors attached to the gauge
harnesses in step ‘a’.
c. Strip one end of the BLAck
wire and crimp to the other butt
connector attached to the gauge
harnesses in step ‘a’.
d. Route the RED wire to the fuse
box. Locate the appropriate fuse
for instrument lighting in the
owner’s manual. cut the RED wire
as required and strip the end.
crimp the push on connector
to the RED wire and connect to
the fuse as shown in Figure 21.
Alternatively, locate power wire to
dimmer switch and install T-tap.
cut the RED wire as required and
strip the end. crimp the push on
T-tap connector to the RED wire
and connect to T-tap on dimmer
power wire.
e. Locate a metal surface that will
serve as an acceptable chassis
ground. cut the BLAck wire to
a sufficient length that will allow
it to reach the chassis ground
and strip the end. crimp the ring
terminal to the BLAck wire as
shown in Figure 21.
f. Drill a 1⁄8” hole, if required, to
attach the ring terminal to the
chassis ground. Caution: If drilling,
check the backside to make sure
there are no components that may
be damaged by drilling.
g. Use the supplied self-tapping
screw to secure the ring terminal
to the chassis ground.
Banks Ram-Air Filter
Installation
62.
Locate the engine air filter
box on the passenger’s side of
the vehicle. Remove the cover by
releasing the four (4) clips on the
Figure 20
16 |
9 6 7 6 7 v . 3 . 0