Banks Power DynaFact gauge assembly (Electronic) - Manual (Page 3)

Note: This gauge package will only
function if a Six-Gun ® or OttoMind ®
module has been previously installed.
The pyrometer gauge will only function
if a thermocouple has been installed in
the exhaust manifold and connected
to the Six-Gun or OttoMind module.
For more information regarding
installation of the thermocouple, refer
to the Owner’s manual for the Six-Gun,
Stinger ® or PowerPack ® .
1.
Choose a suitable location under
the lower edge of the dash for the
mounting of the instrument panel
provided where the driver can
conveniently view it. Note: Molded
pillar mount and additional gauges
are available through Gale Banks
Engineering.
2.
Using the panel as a template,
sdrill two 3 ⁄
16
” diameter holes in the
dash and mount the panel with the
supplied machine screws, nuts and
star washers provided.
3.
Locate the supplied wire loom with
the 4-pin connector. Plug the 4-pin
connector into the corresponding
4-pin receptacle from the Six-Gun or
OttoMind module.
4.
Install the DynaFact boost and
pyrometer gauges in the mounting
panel using the clamps and thumbnuts
provided. Plug the BLACK wire lead to
the male spade terminal on the BLACK
wire of each gauge wire harness. Plug
the YELLOW wire into the Yellow wire
of the boost gauge wire harness and
the RED wire into the RED wire of the
pyrometer gauge wire harness. The
ORANGE wire remains unused.
5.
Connect the 4-pin connector
of each gauge into the back of its
corresponding gauge.
a. Crimp the remaining Black and RED
wires from each 4-pin connector
gauge harness to the butt connectors
as shown in Figure 1.
b. Strip one end of the RED wire and
crimp it to the butt connector
containing the RED wires from step
‘a’.
c. Strip one end of the BLACK wire
and crimp it to the butt connector
containing the BLACK wires from
step ‘a’.
d. Route the RED wire to the fuse box.
Locate the appropriate fuse for
instrument lighting in the owner’s
manual. Cut the RED wire as
required and strip the end. Crimp
the push on connector to the RED
wire and connect to the fuse as
shown in Figure 1. Alternatively,
locate power wire to dimmer switch
and install T-tap. Cut the RED wire
as required and strip the end. Crimp
the push on T-tap connector to the
RED wire and connect to T-tap on
dimmer power wire.
e. Locate a metal surface that will
serve as an acceptable chassis
ground. Cut the BLACK wire to a
sufficient length that will allow it to
reach the chassis ground and strip
the end. Crimp the ring terminal to
the BLACK wire as shown in Figure
1.
f. Drill a 1 ⁄
8
” hole, if required, to attach
the ring terminal to the chassis
ground. Caution: If drilling, check
the backside to make sure there
are no components that may be
damaged by drilling.
g. Use the supplied self-tapping screw
to secure the ring terminal to the
chassis ground.
Gauge Cluster Installation
96790 v.3.0
3