Banks Power Chevy_GMC Trucks: Gas ’99 - 14 4.3,4.8,5.3,6.0,6.2,8.1 Intake- Ram-Air Intake System '09-11 Chevy-GMC (4.8L, 5.3L, 6.0L, 6.2L) Pickups & SUV - Manual (Page 6)

6
96883 v.1.0
Use the Bill of Materials Chart and the
General Assembly Drawing to reference
component nomenclature and location.
Use caution when working in the engine
compartment. Make sure the engine has
been OFF for several hours and cool.
You are about to install the Banks Ram-
Air Intake System. Read and follow all
steps before working on the vehicle.
Some components from the stock air
intake system will remain in service.
Take care when removing stock air
intake components to not damage them.
The images are for general reference
only. Your vehicle application may look
different.
1.
Remove the cover on top of the
engine to gain access to the throttle
body. Lift the cover up to loosen it
from the rubber grommet and set
aside. See figure 1.
2.
Loosen the clamp at the inlet of the
throttle body and separate the stock
intake tube connecting to the throttle
body as shown in figure 2.
3.
Loosen the clamp at the inlet of the
bellow hose and remove the factory
intake tube and bellow hose from the
stock lid cover. See figure 3.
Note: For truck models with a Positive
Crankcase Ventilation (PCV) hose,
disconnect the PCV hose from the
engine. turn the hose clamp at the
engine connection to undo the clamp
and disconnect.
4.
Disconnect the MAF sensor
connector wire harness. Secure the
wire harness away from the air box.
5.
Remove the stock air box by lifting
the air box up and out. The bottom of
the stock air box is held in place by
rubber grommets. There may be some
slight resistance when removing the
stock air box.
Section 2
RAM-AIR INStALLAtIoN
Figure 1