Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA For use with EconoMind Ford (03-09), Chevy(01-08), Dodge (03-07) - Manual (Page 15)

as the system’s oBD II interface
cable is completely installed and
the rJ12 connector is plugged into
the docking station. Although this
charging cable is short and its
circuitry is fuse-protected, the user
is expected to take appropriate
measures to prevent small children
and/or pets from contact with any
part of this system.
28.
Refit the dash panel by carefully
snapping it back into place. Refit the
fuse access panel and tuck any excess
cable behind the panels for a clean
appearance.
29.
your docking station is now
installed and is ready for the
Banks PowerPDA. Install the Banks
PowerPDA into the docking station.
Be sure the Banks PowerPDA is
completely seated in the docking
station against the lower support
bracket.
Note: There may be a snug fit when
installing the Banks PowerPDA into the
docking station. Take care not to force
this process.
30.
Plug the docking station’s
charging cable into the charging
receptacle on the lower edge of the
Banks PowerPDA.
-(Ford 05-07) Skip to Section 4
universal Mount
-Chevy/GMC (‘01-’08) LB7-LMM
-Ford (‘08-’09) Power Stroke
-Dodge (‘06-’07), Cummins
-Cummins Motor home
(‘03-’06)
31.
Locate the universal mount and
docking station in your kit. Interlock
the docking station to the universal
mount by inserting and sliding the
universal mount tabs into the docking
station grooves. See Figure 23.
32.
Find a smooth, flat surface
96803 v.7.0
15
Figure 23