Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Exhaust- Monster Sport Exhaust System 2003-07 Ford 6.0L Ecsb User Manual
Page 9
8.
For crew-cab short-bed models,
it is necessary to replace the factory-
installed frame-mounted hanger
pin that is located behind the rear
transmission crossmember.
A) Using a pry bar, completely remove
the rubber hanger from the front muffler
hanger pin. Remove the two (2) factory
nuts on the front muffler hanger pin
from the frame rail and remove the
hanger pin from the vehicle. Retain
the rubber hanger for re-assembly.
B) Install the supplied hanger pin to the
vehicle frame about 10-16” to the rear
of the original muffler hanger location
(see Figure 2). Install the supplied bolts
and washers into the hanger plate and
through the frame. Install the supplied
nuts and torque to 20 ft-lbs (27 N*m).
c) Reinstall the rubber hanger onto the
mounted hanger pin assembly.
9.
Install the single pin front hanger
clamp onto the rear of the intermediate
pipe with the hanger pin on the inside
facing the muffler. Insert the hanger
pin into the vehicle’s rubber grommet.
Install the inlet of the Banks Monster
muffler to the intermediate pipe.
10.
install the dual pin rear hanger
clamp onto the outlet of the Monster
muffler with the hanger pins on the
inside, facing the muffler.
Figure 2
96571 v.2.0
9