Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '03-07 Compatible with PowerPDA - Manual (Page 17)

96825 v.6.0
17
Figure 14 Banks SpeedBrake Wire Harnesses
If installing Banks SpeedBrake,
proceed to step 1.
If an existing Six-Gun/EconoMind
Tuner has been previously
installed, verify that the Tuner
has the latest version firmware.
Check and compare to the
current version available on the
Banks website. Banks Brake may
not function properly if Six-Gun/
EconoMind Tuner firmware is not
up to the current version. If the
Tuner is not to the latest version
refer to section 10.
If not installing Banks
SpeedBrake, skip to Section 3.
1.
Remove the fuse access panel
below the steering column as shown in
Figure 15.
2.
Remove the fuse box cover, located
in the cabin compartment.
If Six-Gun/EconoMind was
previously installed, continue to
step 3.
If Six-Gun/EconoMind was not
previously installed, skip to step 8.
Removing a Previously Installed
Banks OBD II Interface Cable
3.
Locate the RED single terminal
connector on the Banks ‘OBDII
Interface cable’ and disconnect it from
the mini-fuse blade tap location #22 if
already connected. DO NOT remove
the mini-fuse blade tap as it will be
used for the Banks SpeedBrake wire
harness installation. See Figure 16.
4.
Disconnect Banks OBD II interface
cable from the vehicle OBD II
connector.
5.
Disconnect the 8-pin connector
from the OBD II interface cable from
the 8-pin connector on the Six-Gun/
EconoMind in-cab cable.
Section 2
INSTALLATION OF WIRING HARNESS & CONNECTIONS FOR
OPTIONAL BANKS SPEEDBRAKE