Banks Power Nissan Trucks: (Gas ’04 - 11 5.6L Titan) Intake- Ram Air Intake System '04-09 (Nissan Titan) '04-08 (Nissan Armada 5.6L, 04-08 Infiniti QX56 5.6L) - Manual (Page 6)

6
96498 v.3.0
Use the Bill of Materials Chart and
the General Assembly Drawing to
reference component nomenclature
and location. Use caution when
working in the engine compartment.
Make sure the engine has been OFF
for several hours and cool.
You are about to install the Banks
Ram-Air Intake System. Read and
follow all steps before working on the
vehicle. Some components from the
stock air intake system will remain
in service. Take care when removing
stock air intake components to not
damage them.
1.
Remove the screws holding the
engine cover in place. Use the 10mm
socket wrench. See Figure 2. Set
engine cover and screws aside, they
will be reinstalled.
2.
Remove the engine cover by pulling
up from the back, where the two
rubber grommets are attached to the
cover.
3.
Disconnect the Mass Airflow sensor
(MAF) located on the air filter housing
by squeezing the tab on the connector
with your thumb and pulling away
from the sensor. Set the connector
aside. See Figure 3.
4.
Remove the two PCV vent hose
connections located on the stock tube
resonator. See Figure 4. Remove the
PCV vent hoses from the stock airtube
resonator, by pulling them out.
5.
Remove the stock intake hose by
using the 5/16 nutdriver to loosen both
the hose clamp connecting it to the
air filter housing and the hose clamp
connecting it to the throttle body.
Then remove the intake hose one end
at a time.
6.
Remove the top of the air filter
housing by releasing the two tabs
holding it down and lifting it out. See
Figure 5.
Section 2
RAM-AIR INSTALLATIoN
Figure 2- Removal of Engine Cover Screws