Banks Power 2001-2007 (LB7, LLY & LBZ) Chevy_GMC 6.6L Duramax Turbo-Diesel Pickups - Manual (Page 7)

exhaust clamps to 35 ft-lb.
Note: If a combination hanger/clamp is
utilized, evenly torque nuts to 35 ft-lb.
The clamps only need to be tight
enough to form a seal and hold the
pipes together. Over tightening the
clamps may cause the system to leak
due to the pipe being crimped.
23.
Install exhaust tip by sliding it over
the outlet of the tailpipe. The tip should
be positioned so that the outlet of the
exhaust tip is approximately one (1) inch
past the outlet of the tailpipe.
NOTE: On vehicles with dual rear wheels,
the outlet of the tip should be placed
approximately 3.5 inches past the outlet
of the tailpipe. Torque the band clamp to
35 ft-lb.
24.
Remove the protective covering
from the tailpipe tip.
Caution: the protective covering
may ignite and burn if not removed
prior to running the engine.
25.
You system includes two (2)
Banks Power decals designed to
complement the Duramax emblems on
the vehicles front doors.
26.
Re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections
to prevent disengagement is
recommended. The Banks Monster
Exhaust installation is now complete.
26.
Monster exhaust system
installation is now complete.
Figure 4
96408 v.9.0
7