Danze DC037350 - Installation Manual - Manual (Page 3)

3 
4. Cut out template (Z) at dashed line. Line up
the centerline arrows on the template (Z) with the
centerlines marked on the slab or counter top.
Trace around the outside of the template (Z).
This line indicates where the outer edge of the
lavatory (A) will be after installation.
5. Cut out the inner circle on the template (Z) at
the solid line. Center the template (Z) inside the
marked line and trace the circular opening in the
template on the slab or counter top.
6. Cut a hole in slab or counter top on the inside
line.
7. Assemble faucet and drain (not included) in
lavatory (A) according to the manufacturer’s rec-
ommendations.
8. Apply two continuous beads of adhesive caulk
(not included) just inside the marked line that
indicates where the outer edge of the lavatory
(A) will be after installation. Spread adhesive
caulk slightly with a putty knife or other flat
tool.
9. Set the lavatory (A) into the proper position
in the slab or counter top, using the outside line
as a guide.
InstallatIon InstructIons
For installation on the Ziga Zaga™ or other bathroom vanities
1. Install the Ziga Zaga™ or other bathroom van-
ity according to the Installation Instructions pro-
vided with the bathroom vanity.
2. Use a level to assure that the slab or counter
top is perfectly flat in length and width.
3. Use a pencil to lightly mark the centerlines for
location of the lavatory (A) on the slab or coun-
ter top.
Product dImensIons
3/8 ” HOT
1 1/4 ” WASTE
3/8 ” COLD
24”
11”
20 3/4 ”
20 1/4 ”
14 5/8 ”
15 3/8 ”
16 7/8 ”
18 3/8 ”
7 3/4 ”
8”
3 3/4 ”
5 5/8 ” 5 5/8 ”
FINISHED FLOOR