Danze D461722 - Installation Manual User Manual

Danze For Home

Advertising
background image

• Installation Steps:

• Hardware Provided/Petit matériel de fixation fourni/Se incluye los herrajes:

Mounting Screw/Vis de fixation/Tornillo de montaje

Plastic Anchor/Vis d'ancrage en plastique/Sujetador de plástico

Hex wrench/Clé hexagonale/Llave hexagonal

Versa™ 30" Slide Bar Assembly
Ensamblaje de ducha de mano de 30” con barra Versa™
Ensemble de douche à main de 30 po sur barre coulissante Versa

MC

I N S T A L L A T I O N

Fig 2

Fig 1

Post/
montante/
fixation

Slide bar/
Barra/
Barre coulissante

Base/Base/Base

Cap/
Tapón/Capuchon

Slide body/
Pieza deslizante/
Support coulissant

• Tools Required/Outils requis/Herramientas necesarias:

Flathead Screwdriver/Tournevis á lame plate/Destornillador chato
Phillips Screwdriver/Tournevis Phillips/Destornillador cruciforme
Marking Pencil/Marqueur/Lápiz marcador
Level/Niveau/Nivel
Drill/Perceuse/Taladro
¼” Drill Bit/Barrena de ¼”/Foret de ¼ po (0,6 cm)

This product is packaged partially assembled. You will need to take some

components apart to install.

INSTALL TOP SLIDE BAR POST
1. Remove cap. Using hex wrench (supplied), loosen set screw and
remove post from slide bar base (Fig 1).
2. Locate where you want to install the slide bar. Use the top post as a
template and mark locations on shower wall using pencil (Fig 2).
3. Using the drill bit, carefully drill four holes.
TIP: INSTALL ONE POST, THEN ASSEMBLE SLIDE BAR AND CONFIRM
HOLE POSITION OF SECOND POST BEFORE DRILLING (Fig 3).
4. Insert the plastic wall anchors into the four holes. You may need to tap
them lightly into position with a hammer (Fig 4).
5. Secure post with mounting screws provided (Fig 5).
6. Place and hold the slide bar with slide body onto the post; it should

"click" into place. Tighten the set screw with supplied hex wrench, then
press the cap (Fig 6).

NOTE: When installed correctly, the slide body will have screw holes

located on the bottom side. See Fig 6.

7. Repeat step 5-6 for bottom of slide bar (Fig 7).
8. Attach one hose conical to water supply outlet (not included) and the

other conical to handshower (Fig 8).

D461722
D461723

Advertising