Danze DF012124 - Homeowner Manual - Manual (Page 3)

3 4
2. Lift front of drawer up.
3. Pull drawer completely out of vanity.
4. Remove Phillips head screw at back of glide
and discard entire assembly.
5. With new glide in place, install Phillips head
screw at back of assembly.
6. Lower back of drawer into glide aligning in-
dentations with rear anchors.
7. Lower front of drawer into glide, aligning
holes with lock tabs at the inside front of each
glide channel.
8. Press in glide lock tabs on each side of front of
drawer to complete drawer assembly.
9. The drawer’s position is fi xed and assembled.
Adjusting the vanity glide
If necessary, use the following steps to adjust your drawer alignment.
To raise drawer: Turn height adjustment knob
on each glide channel toward the vanity to de-
sired height.
To lower drawer: Turn height adjustment knob
on each glide channel away from the vanity to
desired height.
Replacing the vanity hinge
1. To remove the door, depress the tab at the
back of each hinge. Be sure to hold the door
with your other hand during this step.
2. Place the door on a soft surface to avoid
scratching and remove the two Phillips head
screws from the hinge.
•
•