RAM Mount RAM-VB-166-SW1 - Manual

Installs in minutes with no drilling required
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
SPECIFICATIONS
Placement
Passenger side, in front, where seat frame meets
floor board.
Drilling Required
None - uses existing seat bolts
Seat Configuration
Bucket
Construction/Finish
Steel/Black Powdercoat
Weight
8 lbs.
Dimensions
A = 16", B = 6.812", C = 6.437"
Hole Center = 13.187"
Pole or Pedestal
Ordered Separately
Features
Shown In Use
Misc.
Rock solid construction
Lifetime warranty
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-166
RAM-VB-166
FORD EXPEDITION EL (LONG CAB VERSION) (2004-2006)
LINCOLN NAVIGATOR (2006-2010)
Note that if your vehicle has welded metal tabs on the passenger side seat leg closest to the door above the seat leg bolt, the RAM-
VB-110 is suggested. These welded metal tabs are used to secure a piece of plastic trim covering the seat frame leg.
A B
C