RAM Mount RAM-VB-101-SW1 User Manual

Ram no-drill, Seat bases, Vehicle base for the

Advertising

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 8410 Dallas Ave S
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]

Vehicle base for the

SPECIFICATIONS

Placement
Passenger side floor board, in front of seat
Between seat frame and floor board

Drilling Required
None - uses existing seat bolts

Seat Configuration
Bucket/Bench

Construction/Finish
Steel/Black Powdercoat

Dimensions

Pole or Pedestal
Sold Separately

Weight
10.7 lbs.

A = 16”, B = 6.75", C = 3.75", D = 7.75”

Hole Center = 13.13”

Features

One 4” riser is included with this vehicle base. Riser allows
optimized placement of mount with a minimal amount of
intrusion of passenger leg space.

RAM No-Drill

Seat Bases

National Products, Inc.

Item Number
RAM-VB-101 & RAM-VB-101-SW1

RAM-VB-101, SHOWN WITH

RAM-VB-SB4 RISER (INCLUDED)

CHEVROLET S-10 4x4 only (1995-2004)
CHEVROLET S-10 BLAZER (1995-2001)
GMC JIMMY (1995-2001)
GMC SONOMA (1995-2004)

Complete Vehicle Mount

RAM-VB-101-SW1

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 8410 Dallas Ave S
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]

Vehicle base for the

INSTALLATION INSTRUCTIONS

1. Attach the RAM-VB-SB4 riser with 5/16” carriage bolts, flat washer, lock washers, and nuts.

2. Remove the two front seat bolts that connect the passenger seat to the floor. These may be under plastic caps.

3. Tilt the front of the passenger seat upward to clear the studs and slide the No-Drill™ base under the seat until the
slots in the base line up with the seat bolt studs

4. Lower the seat back down into position.

5. Install the two front seat nuts and fully tighten.