RAM Mount RAM-VB-105-SW1 - Manual

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Vehicle base for the
SPECIFICATIONS
Placement
Passenger side on the floor, at front of seat
Drilling Required
No - uses existing seat bolts
Seat Configuration
Bucket
Construction/Finish
Steel/Black Powdercoat
Dimensions
Pole or Pedestal
Sold Separately
4” riser included for better positioning of
pedestal in later model vehicles.
Weight: 2.1 lbs.
A = 14.75", B = 3.8", C = 1.75”
Hole Center = 13.125”
Notes
Complete Vehicle Mount
RAM-VB-105-SW1
Vehicle Base
RAM-VB-105
Low profile design keeps mount away from passenger leg
space. This base will not interfere with factory installed
console or 4WD lever.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-105 & RAM-VB-105-SW1
DODGE DAKOTA (1997-2011)
DODGE DURANGO (1997-2003)
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Move the passenger seat back to its rearmost position and remove the front seat rail bolts on the passenger side.
2. Without moving the seat, place the No-Drill™ base over the front of the seat frame legs.
3. Align the holes in the base with those of the seat frame legs. The pedestal platform should be near the console.
4. Re-install the seat bolts and fully tighten.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-105 & RAM-VB-105-SW1
DODGE DAKOTA (1997-2011)
DODGE DURANGO (1997-2003)