RAM Mount RAM-VBD-128-SW1 - Manual

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Vehicle base for the
SPECIFICATIONS
Placement
Flat surface/floor
Drilling Required
Yes
Seat Configuration
Bucket/Bench
Construction/Finish
Steel/Black Powdercoat
Dimensions
Pole or Pedestal
Included
Weight
3.6 lbs.
A = 8", B = 8", C = 13"
Features
Universal base for any vehicle with a vertical flat mounting surface
Rugged Steel Construction
Lifetime warranty
RAM Drill Seat Bases
National Products, Inc.
Item Number
RAM-VBD-128 & RAM-VBD-128-SW1
A
B
C
UNIVERSAL (ALL VEHICLES)
Complete Vehicle Mount
RAM-VBD-128-SW1
Vehicle Base
RAM-VBD-182
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
National Products, Inc.
Website: www.ram-mount.com
Email: [email protected]
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Place base on vertical flat surface so that the pedestal is in the optimum location.
2. Mark the mounting hole locations. Please note that it might be necessary to shim a corner of the mounting base if
the mounting surface is uneven.
3. Drill 17/32” holes in surface at all of the marked locations. Be extremely careful not to damage any equipment
behind mounting surface when drilling.
4. Tighten base in place using bolts, washers, and nuts. If floor is less than 1/4” thick, please use fender washers on
the back of mounting surface to help distribute the weight.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
National Products, Inc.
Item Number
RAM-VBD-128 & RAM-VBD-128-SW1
RAM Drill Seat Bases
UNIVERSAL (ALL VEHICLES)